The automatic awning requires 120-volt AC power from shower power, the inverter or the generator to operate. A thermal override is installed to prevent damage to the motor from overuse and can require up to an hour for the motor to cool and reset. In this instance, the manual override feature will retract the awning.

Controls to adjust the automatic awning are located on the motor. A black plastic key used for awning adjustment is provided with the awning OEM manual in the RV gray box. Refer to the OEM manual for adjustment instructions.

A wind sensor, or anemometer, is installed onto the top of the RV roof to monitor outdoor conditions. If wind speed surpasses the setting on the controller dial and A/C power is available, the awning will automatically retract to prevent damage. The awning will not automatically extend. When wind speed falls below the preset setting, extend the awning using the wall switch or remote control. Use caution when driving under low overhangs or tree branches to avoid damaging the wind sensor. If the wind sensor is damaged, have it immediately replaced. The wind meter is factory preset at 22 mph. Increase of this setting will risk voiding the warranty. The anemometer may appear more sensitive in some situations due to parking angles and placement of the components on the roof.

During rain keep the awning fully in or fully out. Partial extension will prevent the fabric from being taut and water build up can create sagging. The awning comes factory preset for rain runoff. If water collects on the awning, use a broom to remove build up.

Creaking and groaning in awning arms indicate a need for lubrication. Spray silicone through the pins at the arm, shoulder and wrist to lubricate springs located inside. Awning shudders during retraction could indicate the pins are dry. Spray with silicone.

Keep the awning free of debris. Rolling up the awning with twigs, nuts, pine cones, etc., can create holes in the fabric. Do not use detergent to wash the awning. Detergent can wash away awning water repellency. Only spray the fabric with water. Pressure washing is allowed, but use low pressure and stand back a distance from the awning. If extra scrubbing is necessary, use a mild natural soap and a soft brush. To remove pine tar, use FeronClean (one word), available at most pool/patio shops. Water repellant sprays can sometimes change fabric color. Test chemicals and soaps on a small area of the awning before full treatment application.

When adding screening material to extend below the awning, avoid heavy weights that can damage the vehicle in the event of automatic retraction. Instead, use a soft sandbag weight to hold screening in place.

Adding automatic awnings after market is dependent on the RV's power availability. Contact your selling dealer or a certified technician for more information.

Black plastic allen wrench to adjust the motor limit switches.