1. Problem: Loose Outlet
Solution: Turn off power at the main disconnect. Remove the faceplate and set off to one side You may want to tape the screws to the faceplate to prevent misplacing them. Before disconnecting wires, make a quick sketch of how they run. Hook up a new receptacle with a UL rating. Push the receptacle and wires back into the wall box. Replace the faceplate and tighten the screws. Note: Some wall outlets are crimp-on type and these will require a special tool.
2. Problem: Wood Damage
Solution: Light scratches may be erased by careful rubbing with furniture polish and paste wax. Dents may be minimized by steam. Place a damp clean cloth over the area and apply a steam iron heated to medium-high. Deep gouges and nail holes can be filled with wood putty. Sand repaired holes and deep scratches using a fine grain sandpaper, moving in the direction of the grain. Apply a stain that closely matches the surface. Let dry and follow with a coat of clear lacquer (open windows for ventilation). Finish luster by rubbing the area with 0000 type steel wool.
3. Problem: Rock Chips in Paint
Solution: Position area to be painted out of direct sunlight. Clean the surface with soap and clear water. Dry thoroughly. Apply matching paint to the rock chips in smooth layers using a fine brush. Allow up to two hours drying time between layers. Flakes in metallic paint may float to the surface and require numerous applications to lay flat. Once finished, allow the surface to dry overnight and then add gloss using clear acrylic nail polish.
4. Problem: Squeaky Hinge
Solution: Use a flat screwdriver or putty knife to pry up the hinge pin approximately ¼ inch. Drop a scant amount of light oil into the barrel. Catch excess oil with a rag. Tap the pin back into place and swing the door back and forth. If the hinge continues to squeak, open the door. Drive a wood wedge under the hinge side and remove the pin. Lightly sand the pin and barrel using steel wool. Apply a light coating of oil to the pin and replace.
5. Problem: Stained Countertop
Solution: Remove stains from solid surface countertops using an abrasive cleaner and Scotch-brite pad. Stains on laminate vinyl counters can usually be removed with a baking soda/water paste. More stubborn stains on laminate countertops can be removed with a solvent designed specifically for use on this type surface.
6. Problem: Tangled Cords and Hoses
Solution: Fully extend cords and hoses to remove kinks. Wipe off dust and debris. Wind each cord and hose separately. Secure using a plastic wire tire and store inside plastic buckets.
7. Problem: Awning Tear
Solution: Patch kits are available at most RV supply outlets. Wash and dry the fabric. Trim away jagged edges. Overlap two strips of clear awning tape on the bottom and one strip on top.
8. Problem: Stubborn Screw
Solution: Slide a screwdriver tip sideways in the slot to clear away dirt. If the slot is too narrow, widen the slot using a hacksaw. Turn the screw, working it back and forth with the screwdriver. Once the screw is out a few turns, grip the screw using lock-joint pliers.
9. Problem: Clogged Sink
Solution: Pour into the drain ½ cup of baking soda followed by ½ cup of vinegar and let stand for three hours. If the clog is due to grease, pour ½ cup of salt followed by ½ cup of baking soda followed by 2 cups of boiling water and let stand overnight (note: add boiling water to a ceramic sink only when there is already standing water present in the basin). Position a plunger over the drain. If necessary, fill the sink to cover the head of the plunger. Rapidly move the plunger up and down to dislodge clogging from the drain.
10. Problem: Frozen Nut or Bolt on Chassis
Solution: Use a tool that fits the nut to avoid stripping the head. Spray the nut or bolt with a penetrating oil and let it sit for ten minutes. Move the nut or bolt back and forth. Take your time and continue spraying with penetrating oil. For more stubborn sticking, heat the nut or bolt using a torch. Once hot, remove heat. Allow the nut or bolt to cool and use the tool to remove.